When to use it
After setting the NumberOfDemandPieces property and anytime before the OnFinish event ends.
ExternalID: Long /*[in]*/
With this method you may set the size of each piece to be cut.
The number of pieces to be cut is given by the NumberOfDemandPieces property.
The length of each piece can be get using the GetDemandPiece method.
Index - the index of the piece whose information are set. This number is in range [0...NumberOfDemandPieces - 1].
Length - the length of the piece. This number must be integer. For working with real numbers read here.
Angle1 - the angle of one extremity of the piece (from bottom part of the piece). The angles must be expressed in degrees between 0 and 180.
Angle2 - the angle of the other extremity of the piece (from bottom part of the bar).
ExternalID is an integer number which is assigned to each piece in order to be easier identified.
back to index