Name
ManualArrangeGlueCuts
When to use it
When the optimization process is NOT running.
NOT during the OnFinish or OnAfterManualArrange event.
After all other information has been set.
Prototype
HRESULT ManualArrangeGlueCuts(
IndexCut1: long /*[in]*/,
IndexCut2: long /*[in]*/,
IndexCut3: long /*[in]*/,
IndexNewCut1: long /*[out]*/,
IndexNewCut2: long /*[out]*/,
IndexNewCut3: long /*[out]*/,
AllowJoin: long /*[out]*/
);
Explanations
Rearrange 3 existing cuts as shown in the picture. Two cuts are glued together and another one is broke into two smaller cuts. Some preconditions must be met by the cuts to be arrange.
Parameters
- IndexCut1, IndexCut2 and IndexCut3 are the indexes of 3 existing cuttings. Two of them must be collinear and perpendicular on the third one. The order is not important.
- IndexNewCut1, IndexNewCut2 and IndexNewCut3 are the indexes of the new cuts. IndexNewCut1 is the index of the cut obtained by glueing the other cuts.
- AllowJoin - This parameter will receive value 1 if the glue operation is possible. Otherwise it will return 0.
See also
How to arrange pieces manually, OnAfterManualArrange.
Links