Name
ManualArrangeRemoveCut
When to use it
When the optimization process is NOT running.
NOT during the OnFinish or OnAfterManualArrange event.
After all other information has been set.
Prototype
HRESULT ManualArrangeRemoveCut(
IndexCut : long , /*[in]*/
IndexRemovedWaste1: long , /*[out]*/
IndexRemovedWaste2: long , /*[out]*/
IndexInsertedWaste: long /*[out]*/
);
Explanations
Removes a cut if this is possible. A cut can be removed only if there is no piece attached to it.
Parameters
- IndexCut - the index of the cut to be removed.
- IndexRemovedWaste1, IndexRemovedWaste2 - the indices of the waste rectangles that were previously separated by the cut.
- IndexInsertedWaste - the index of the newly obtained waste rectangle. This waste was obtained by joining the waste rectangles IndexRemovedWaste1, IndexRemovedWaste2.
See also
How to arrange pieces manually, ManualArrangeAddCut, ManualArrangeIsValidRemoveCut, OnAfterManualArrange.
Links